Inovasi Paving Block Ramah Lingkungan dengan Memanfaatkan Limbah Geodipa Sebagai Pengganti Sebagian Semen

Fikroni; Agus Juara; Suharto

doi:10.34001/ces.v3i02.736

Fikroni Universitas Sains Al-Qur'an
Agus Juara Teknik Sipil Universitas Sains Al-Quran Wonosobo
Suharto Teknik Sipil Universitas Sains Al-Quran Wonosobo

DOI: https://doi.org/10.34001/ces.v3i02.736

Keywords: Innovation, Geodipa Waste, Paving Blocks

Abstract

The increasing growth of the factory industry has created new attention to waste which needs to be managed more seriously so that it can provide benefits, especially in the construction sector. For this reason, it is necessary to conduct research on this problem. In this study, researchers conducted research using geodipa waste. The percentage of geodipa waste used in this research is 3%, 5%, 8%, 10% and 12% of the cement weight requirement using a mixture of 1PC:6Ps and 100 ml of water for 1 paving block with a mold thickness of 6 cm, width 10 cm, 20 cm long using manual tools. The test results using geodipa waste for a mixture of an average of 8% compressive strength test produced were 16.13 MPa for Rp. 1,066,-/seed according to SNI-03-0691-1996 including class C quality (can be used for pedestrians) while for the normal mixture the resulting compressive strength test was 11.33 MPa for Rp. 1,100,-/seed including class D quality (can be used for parks and other uses) From the results of the compressive strength test of the paving blocks, it can be concluded that the addition of geodipa waste produces better results.

References

Tjokrodimulyo, Teknologi Beton. Yogyakarta: Jurusan Teknik Sipil Fakultas Teknik UGM, 2007.

S. Ragil Habib Sidik, Nasyiin Faqih, “Pengaruh Pemanfaatan Limbah Geodipa Sebagai Bahan Pengganti Sebagian Semen Serta Penambahan Serat Karet Ban Bekas Terhadap Kuat Tekan Beton,” J. Teras, vol. 12, no. 2, pp. 69–74, 2022.

M. ’ Riyono, W. Lestarini, and A. Juara, “Pengaruh Kuat Tekan Beton Dengan Limbah Biji Salak Kering Sebagai Pengganti Sebagian Agregat Kasar,” J. Teras, vol. 12, no. 1, p. 2022, 2022.

M. F. Salim, D. E. Diastyari, and L. U. W. Widodo, “Pemanfaatan Geothermal Sludge Untuk Pembuatan Bata Ringan,” J. Tek. Kim., vol. 13, no. 2, pp. 57–60, 2019, doi: 10.33005/tekkim.v13i2.1411.

R. E. Kurniawan, “PENGARUH PENYIRAMAN TERHADAP KUAT TEKAN DAN PERMEABILITAS PAVING STONE GEOPOLYMER BERBAHAN DASAR ABU TERBANG,” Rekayasa Tek. Sipil, vol. 02, no. 02, pp. 24–35, 2017.

A. Juara and A. B. Setiawan, “Analisa Biaya Pembuatan Paving Block Mutu K-200 Dengan Potongan Kawat Bendrat Sebagai Bahan Tambah,” J. Tek. Sipil, vol. 12, no. 1, pp. 1–10, 2021.

M. Qomaruddin and S. Sudarno, “Influence of Bottom-Ash Mixed with Gypsum as Concrete Bricks for Wall Construction Material,” J. Appl. Environ. Biol. Sci., vol. 8, no. 4, pp. 0–5, 2018.

ASTM-C.1319–01, Standard Specification for Concrete Grid Paving Units 1, vol. 04. 2001, pp. 1–2.

SNI 15-2531-1991, “Metode Pengujian Berat Jenis Semen Portland,” Badan Standar Nas. Indones., p. 2531, 1991.

M. Qomaruddin, A. Ariyanto, K. Umam, and Y. A. Saputro, “Studi Komparasi Karakteristik Pasir Sungai Di Kabupaten Jepara,” J. Ilm. Teknosains Univ. PGRI Semarang, vol. 4, no. 1, 2018.

M. Qomaruddin, A. I. A. Saputra, T. H. Munawaroh, Z. Isnaini, and S. I. Ariyani, “Pemanfaatan Air Bersih Masyarakat Pada Program Pamsimas di Desa Raguklampitan Kabupaten Jepara,” Pros. Semin. Nas. Publ. Hasil-Hasil Penelit. dan Pengabdi. Masy., no. September, pp. 571–578, 2017.

SNI-03-2816-1992, “Metode pengujian kotoran organik dalam pasir untuk campuran mortar atau beton,” in Bandung: Badan Standardisasi Indonesia, vol. 4, 1992, pp. 2–3.

D. Larasati, Iswan, and Setyanto, “Uji Kuat Tekan Paving Block Menggunakan Campuran Tanah dan Kapur Dengan Alat Pemadat Modifikasi,” JRSDD, vol. 4, no. 1, pp. 11–22, 2016.

SNI 03-1968, “Metode Pengujian Tentang Analisi Saringan Agregat Halus dan Kasar,” Badan Standar Nas. Indones., pp. 1–5, 1990, [Online]. Available: http://staff.uny.ac.id/sites/default/files/pendidikan/dr-slamet-widodo-st-mt/sni-03-1968-1990.pdf.

SNI 1969-2008, “Cara Uji Berat Jenis dan Penyerapan Air Agregat Kasar,” Standar Nas. Indones., p. 20, 2008.

SNI 03-4804-1998, “SNI 03-4804-1998 (Bobot Isi Agregat),” Sni 03-4804-1998, pp. 1–6, 1998.

SNI 03-1970-1990, “Metode Pengujian Berat Jenis dan penyerapan air agregat halus,” in Bandung: Badan Standardisasi Indonesia, 1990, pp. 1–17.

A. Ariyanto, K. Umam, and Y. A. Saputro, “Komparasi Karakteristik Mortar Dengan Menggunakan Pasir Sungai Klepu Dan Pasir Sungai Batealit Kabupaten Jepara,” Rev. Civ. Eng., vol. 3, no. 1, pp. 23–28, 2019, doi: 10.31002/rice.v3i1.1279.

BSN, “Metode Pengujian Konsistensi Normal Semen Portland Dengan Alat Vicat Untuk Pekerjaan Sipil. SNI 03-6826-2002,” Badan Standarisasi Nas. Jakarta, p. 6826, 2002.

A. T. Aditama, Analisis gradasi agregat sebagai upaya perbaikan karakteristik campuran aspal beton geopolimer, no. Rc 142501. 2017.

M. Qomaruddin, H. A. Lie, A. Hidayat, S. Sudarno, and A. Kustirini, “Compressive Strength Analysis On Geopolymer Paving By Using Waste Substitution Of Carbide Waste And Fly Ash,” 2019, doi: 10.1088/1742-6596/1424/1/012052.

Environmentally Friendly Paving Block Innovation by Utilizing Geodipa Waste as a Partial Substitute for Cement

Abstract

References